Magnetek GPD 333, Technical Manual

Page: 34 / 81

21
1. Press the PRGM/DRIVE key during stop to enter the
Program mode.
2. Press
▲
or
▼
key to select the constant number to be
read/set.
3. Press the DATA/ENTER key and the selected constant
data are displayed.
4. Press
➤
/RESET ,
▲
or
▼
key to set the data.
• To change the sign of data
(constant no-23 only), press
▲
or
▼
key when the far left digit is selected.
Minus data: Far left digit = " – "
Plus data: Far left digit is blank
5. Press the DATA/ENTER key to write-in the data. If the
set value exceeds the setting range, the whole display blinks for
3 seconds, then the original value is again displayed. When the
set value is within the setting range, "
End " will appear on the
Digital Display for 1 second, then the new set value is dis-
played.
6. Press the DSPL key to display the constant number
again.
7. Repeat steps 2-5 to read/set other constants.
8. When finished with constant programming, press the
PRGM/DRIVE key to return to Drive mode.
Displays appearing only on the Digital Operator:
+ DATA
" ■ ■ " ■ ■ . ■ ■ ■ ■
– DATA
"–" ■ ■ . ■ ■ ■ ■
CONSTANT STATUS MONITOR DISPLAY RESULT
Accepted
" End "
( 1 sec )
Indicates constant setting was
written into EEPROM.
Not accepted
Blinking for 3 seconds,
then return to former
data display
Indicates constant setting was
not written into EEPROM.
efesotomasyon.com - Yaskawa ac drive,servo motor