MADRIX STELLA, User Manual

Page: 16 / 115

[Part 2] Device Configuration
//16
www.madrix.com
MADRIX STELLA User Manual
Enable RDM - Allows the device to receive and send Remote Device Management
data on the specific port.
§
Disable RDM on the specific port, when using STELLA for DMX-IN.
§
Only enable RDM if you wish to use it. Otherwise, disable RDM to avoid
any potential issues.
Device Accepts Network Data From - Defines the data source for the device.
Choose from the following options:
§
Art-Net
§
Streaming ACN
§
Art-Net And sACN
DMX Output
Configuration
This section shows the settings for the DMX ports when used for output [DMX 1 and
DMX 2].
Confirm with Set
Channel Offset - Allows you to shift the received DMX universe [512 DMX
channels] per port if required.
§
This will modify the output.
§
+1 To +511 - Adding a positive channel offset will shift the received channels
to higher channel numbers.
- Example: Received channel #1 will be shifted to channel #11 by using a channel
offset of 10.
- That means that new channels are added to the data [in front of the received
data block, with DMX value 0], while any channels that now would be higher than
512 will be removed.
- Example, continued: Channels 1 to 10 are newly added, while channels 503 to
512 are removed.
§
-1 To -511 - Adding a negative channel offset will shift the received channels
to lower channel numbers.
- Example: Received channel #512 will be shifted to channel #412 by using a
channel offset of -100.