MADRIX STELLA, User Manual

Page: 9 / 115

[Part 1] Overview
//9
www.madrix.com
MADRIX STELLA User Manual
Daisy-Chain Support
STELLA features 2 separate Ethernet network ports. Either one is fully functionally for IN and OUT and can be used for
the data connection without using a separate network switch or router.
We recommend to connect a maximum of 40 units after one another in a row, when using Art-Net in Unicast Mode or
Streaming ACN Multicast at a max. data rate of 50 FPS / 20 ms without any additional devices in the network.
In the MADRIX 5 Software, we highly recommend to activate ArtSync for excellent image quality [see below].
Reset To Factory Default Settings
In rare cases, you might need to do a reset to factory default settings, for example to reset to the device to its default
IP address as shown on the side of the device:
Reset Via Reset Button
§
1] Disconnect all connections from the device [power, data, DMX].
§
2] Use a suitable tool to press the reset button [between DMX 1 and 2].
§
3] Continue to press the reset button and supply power again over 'Power' or USB.
§
4] Continue to press the reset button and wait until all status LEDs of the device flash repeatedly or wait 10
seconds.
[Simply repeat these steps should the process fail.]
Reset Via Ethernet [Web Configuration]
§
1] Connect MADRIX STELLA to power.
[Please see safety instructions in the MADRIX STELLA Technical Manual & Quick Start Guide ]