MADRIX STELLA, User Manual

Page: 24 / 115

[Part 3] Using MADRIX 5 Software
//24
www.madrix.com
MADRIX STELLA User Manual
§
9] Optimized Frames Or Full Frames
§
10] Sync Mode
§
Additional Art-Net Device Settings
DMX-OUT Via Ethernet Network [Art-Net]
You can connect the STELLA over Ethernet network to the network card of your computer that runs the MADRIX 5
Software. Data is distributed to the STELLA over network cabling [Ethernet] and sent to the two ports [DMX 1 and
DMX 2].
1] Initial Configuration
§
Put MADRIX STELLA into operation; as described above. Learn more »
Putting The Device Into Operation
§
Connect MADRIX STELLA to your computer using Ethernet network cabling.
§
It is highly recommended to use Gigabit Ethernet network components [network card, switches, etc.].
§
Set up the corresponding settings in the »
Configuration Using A Web Browser
2] Windows Network Settings
Art-Net is a network-based protocol. MADRIX 5 will use the network card of your computer to send data.
§
It is required to set up the correct network settings in Windows, first.
§
You must use these IP address and Subnet mask settings. Otherwise, Art-Net might not work!
§
The IP addresses of your computer and your MADRIX STELLA devices need to be different.