LXE MX3X, Reference Manual

Page: 35 / 150

Enter Data 25
E-EQ-MX3XRG-A MX3X Reference Guide
Integrated Laser Scanner Data Entry
Read all cautions, warnings and labels before using the laser
scanner.
To scan with the integrated laser barcode reader, point the laser window towards a barcode and
press the Scan button. You will see a red laser beam strike the barcode. The MX3X has an SE923
scan engine.
Correct Scan Incorrect Scan Incorrect Scan
Figure 1-16 Scan Beam
Align the red beam so that the barcode is centered within the beam. The laser beam must cross the
entire barcode. Move the MX3X towards or away from the barcode so that the barcode takes up
approximately two-thirds the width of the beam.
Figure 1-17 Scanner LED Location
The SCNR LED turns red when the laser beam is on. Following a barcode scan and read the
SCNR LED turns green and the MX3X beeps, indicating a successful scan.
The laser and SCNR LED automatically turn off after a successful or unsuccessful read. The
scanner is ready to scan again when the Scan key is pressed.
Large barcodes can be scanned at the maximum distance. Hold the imager closer to small
barcodes (or with bars that are very close together).
When the scan is successful, the Scan LED turns green, then switches off, and the MX3X will
produce a distinctive audible tone.
When the scan is unsuccessful, the SCNR LED remains red until the 3 second timeout (default)
occurs or the Scan key is released. The MX3X will produce distinctive audible tones. Check the
following:
•
Check the barcode for marks or physical damage e.g. ripped label, missing section, etc.
•
Try scanning test symbols of the same code type at different distances and angles.
•
Is the scan aperture unscratched and unsoiled?