Lupus Electronics LUPUSEC-XT2, Manual

Page: 89 / 148

89
ENGLISH
Put the window/door contact into operation
1.
Remove the battery breaker from the back of the contact to energize the
window/door contact.
2.
Open the main menu of the alarm system.
3.
Open the menu “Sensors”  “Add”.
4.
Click on Start.
5.
Press the Test button of the window/door contact. A red LED lights up.
6.
The control unit will confirm the successful addition with a brief signal, display the
sensor and then list it in the Sensors menu.
7.
Start the range test in the control unit and take the window/door contact to the
intended place of installation.
8.
Then press the Test button. If this position is within the range, a red LED lights up
at the window/door contact.
9.
Test the signal strength in the Range menu of the alarm system (1-9).
10.
If the position is suited, you can install the window/door contact.
Installation:
Install the magnet to the side of the door or window and attach the
window/door contact to the frame. Observe the markings (9) to
position the magnet exactly.
Note:

The distance between magnet and window/door contact must not exceed 20 mm.

You can either fasten both components with screws or fix them with the supplied
adhesive pads. We recommend fastening a thin cardboard strip, plastic strip, or
similar between tamper contact and adhesive pad to prevent the tamper contact
from poking into the adhesive pad and thus triggering tamper alarm. At any rate,
make sure that the adhesive pads cannot come off without external influence.

Do not bridge JP1 to allow the signal transmission to the control unit whenever the
battery is checked.

After pressing the Test button, the LED indicator of the window/door contact lights
up briefly for three minutes every time the contact is opened or closed. After the
three minutes, the LED indicator does not light up anymore.
Wireless indoor siren
Product description:
1.
Battery compartment
2.
DIP switch
3.
Tamper contact
4.
Mounting holes
Scope of delivery: