Lupus Electronics LUPUSEC-XT2, Manual

Page: 135 / 148

135
ENGLISH
6.
Function switches
7.
Tamper contact
8.
Tag (watertight)
LED indicators:
Both LEDs are off in the stand-by mode.

Power LED (green):
o
If a button is pressed, the Power LED lights up for 5 seconds to indicate the
operational readiness of the tag reader.
o
The Power LED flashes instead of being on constantly to indicate the battery
running low.

Status LED (red):
o
Flashes fast upon signal transmission.
o
Is permanently on in tag learn mode.
o
Flashes in installation mode.
Battery:

The tag reader requires three AAA 1.5 V alkaline batteries. The average battery
life with two activations per day is approx. four years.

The tag reader indicates the low battery status by the Power LED flashing. The
control unit is additionally informed about the battery status.
Power saving function:

As long as the tag reader is not used, it does not consume any electric power.
Only when a button is pressed is the tag reader activated for 5 seconds.

The tag reader goes off again automatically after 5 seconds.
Tamper protection:

The tag reader is protected against being opened in an unauthorized way or being
removed from the mounting surface.

If the tamper contact is triggered, the Power LED lights up and a warning signal
sounds. The control unit is informed about the tampering.

If the control unit is armed, the triggered tamper contact triggers an alarm.

In learn mode, the tamper contact is deactivated.
Function switches:
If the tag reader housing is open, you will see the function switch block with five
switches. These switches are all set to OFF by default.
Switch no. Position Description
SW 1
ON Learn / add mode
OFF Normal Operation Standard)