Lupus Electronics LUPUSEC-XT2, Manual

Page: 108 / 148

108
ENGLISH
life is approx. three years. The control unit will inform you in case of a battery running
low.
Installation:
We recommend installing the PIR network camera at a location which:

A possible burglar will pass for sure

Is at a height between 1.9 and 2 metres

Is in the corner of the room for optimal overview

Provides for an unrestricted field of view over the room

The detection range is approx. 12 metres with the camera installed at a height of 2
metres.

Do not install the PIR network camera with direct view to a door or window
secured by a window/door contact. In case of an alarm, both alarm signal may
interfere and may not be recognized.

Do not install the PIR network camera within the detection range of another
detector (e.g. motion detector with light in front of the entrance door).

Do not expose the PIR network camera to direct sunlight.

Do not install the PIR network camera close to heaters or air conditioning systems
or in a conservatory.
Test mode:
Press the Test button for approx. 5 seconds (JP2 must be activated) to set the PIR
network camera to Test mode. During this time, the LED lights up upon every motion.
Use this function for optimal alignment.
Warm-up phase:
The PIR network camera is set to a one-minute warm-up phase every time the
system is armed or set to home mode. During that phase, it cannot detect any
motions. Do not trigger any motions, as otherwise the warm-up phase extends by
another minute.
Standby mode ON/OFF jumper (JP2):

Jumper activated (delivery status)
If the camera detects further motions after a motion detection alarm, it will raise
another alarm and take a new picture at intervals of approx. 20 seconds.

Jumper deactivated
After each motion detection, the camera goes into a “sleep” mode to save energy. If
another motion is detected during this time, the “Sleep mode timer” extends by
another minute.
Note: