Lupus Electronics LUPUSEC-XT2, Manual

Page: 142 / 148

142
ENGLISH
Installation:
You can install the PIR/ microwave motion detector on flat surfaces as well as in
corners:

Mounting to flat surface:
To mount the detector to a flat surface, use the mount with the swivel ball head.
Arrest the mount with the screw on top.

Mounting with corner mount:
To mount the detector in a corner, use the provided corner mount.
Note:

The LEDs (on the front) and the single mounting hook (on the back) must point
upwards for the assembly.

First, tighten the respective mount to the intended place of installation.

Then place the PIR/microwave motion detector on the respective mount. The
mounting hooks need to lock in place on the back of the motion detector.

The horizontal angle of the PIR / microwave motion detector is 110°.

To enable optimal motion detection, we recommend installing the PIR/microwave
motion detector at a height of 1.9 to 2.0 metres with the back vertical to the wall.

Do not install the motion detector within the detection range of other detectors
(e.g. motion detectors with light).

Do not expose the motion detector to direct sunlight.

Do not install the motion detector close to heaters or air conditioning devices.

Unless in test mode, the motion detector is able to detect a motion every three
minutes only (irrespective of the control unit status).