Lupus Electronics LUPUSEC-XT2, Manual

Page: 92 / 148

92
ENGLISH
differently, you should delay the installation of these sirens or just disconnect
these sirens from the power supply while the settings are changed. It is impossible
to read out the current siren configuration.
Battery:
The wireless indoor siren requires 4 D-cell alkaline batteries. The average battery life
is 2 years (depending on the usage).
Warning sounds and signals of the indoor siren:
Note:

The siren will sound warning signals, if either a tamper contact is open, a sensor
battery is low, or another defect is detected (even if the audio warning signals were
deactivated in the control unit).
Wireless outdoor siren
Product description:
1.
Mounting holes
2.
Tamper contact
3.
DIP switch
4.
Lock screw
5.
On/off switch
Scope of delivery:
4 x dowels
4 x 1.5 V D alkaline batteries
Put the wireless outdoor siren into operation
1.
Open the wireless outdoor siren by unscrewing the screw at the bottom.
2.
Turn the on/off switch (5) to ON. A brief signal sounds.
Audio signal Signal lamp
Arm/Home 1 beep* The 3 LEDs light up once
Disarm 2 beeps* The 3 LEDs light up once one after another
Arm (battery low) 5 beeps The 3 LEDs light up three times
Disarm (battery low) 5 beeps The 3 LEDs light up twice one after another
Arm (tamper) 5 beeps The 3 LEDs light up three times
Disarm ( tamper) 2 beeps* The 3 LEDs light up twice one after another
Pre-alarm 3 sec beep The 3 LEDs light up twice one after another
Tamper alarm Continuous beeps The 3 LEDs light up once one after another
Entry/exit signal
Constant beep until the time
has elapsed
Nothing