Lupus Electronics LUPUSEC-XT2, Manual

Page: 125 / 148

125
ENGLISH
Heat detector
Product description:
The heat detector is equipped with two internal sensors, which on the one hand
measure the velocity of the temperature increase and on the other hand the actual
ambient temperature. If the temperature rises at more than 8.3 °C per minute or the
ambient temperature exceeds 57.3 °C, an alarm is triggered. The heat detector is
usually installed in kitchens, as customary smoke detectors often cause false alarms
due to the formation of smoke.
1.
Red LED

On, if batteries are low or a defect is available

On for 2 seconds: alarm is transmitted

Flashes every 30 seconds: low battery
2.
Test button

Activates the test and range mode

Deactivate alarm
3.
Battery compartment
4.
Installation notch
5.
Retaining fixture
Battery:
The heat detector requires three AA batteries 1.5 V. The average battery life is three
years. The heat detector will inform the control unit, if the battery is running low about
two months before they are empty.
Put the heat detector into operation:
To put the heat detector into operation, proceed as follows:
1.
Insert the supplied batteries.
2.
After their insertion, the heat detector emits two short beeps and the LED lights up
once in red.
3.
Close the housing.
4.
Open the configuration page of the control unit, open the menu “Sensors”  “Add”
and click on Start.
5.
Press the test button of the heat detector for about one second.
6.
The configuration page of the control unit should list the heat detector.
7.
Add the heat detector.