Lupus Electronics LUPUSEC-XT2, Manual, Page: 32 / 148

32
ENGLISH
Add
In the menu “Add”, you can add sensors to the LUPUSEC-XT2. Simply click on
“Start” next to “Add” to start the automatic sensor search. Then, start the test of the
(“Learn”) mode sensor to install. Read the sensor description to find out, how to add
the sensors. Usually, the sensor is equipped with a button to be pressed for a certain
time.
If the sensor was found, it is listed in the table, which also shows the type of contact
(“Type”), the reception quality (“Signal strength”) and the unique “Sensor ID” of each
sensor.
You can add the sensor to the alarm system via the action “Add”. You can assign
properties to the added sensor, as explained in the previous section “Edit sensor”.
You can add sensors manually via the sensor-specific sensor ID – which is
unnecessary in most of the cases.
Range
Test the sensor range with the “Range” function. After having successfully added a
sensor, click on “Start” in the “Range” menu (

The LEDs of area 1 + 2 flash). Take
the sensor to the intended point of installation. Press the Test button of the sensor for