LSIS H100, Operation Manual

Page: 82 / 610

Learning to Perform
Basic Operations
68
3.2.8 Setting the Monitor Display Items
In Monitor mode, 3 different items may be monitored at once. Certain monitor items, such
as the frequency reference, are selectable. The display items to be displayed on the screen
can be selected by the user in the Config (CNF) mode. However, in HAND mode or in OFF
mode, the first display item is permanently fixed as the frequency reference. On the top-
right corner of the keypad display‘s status bar, another frequency item is displayed. This
item refers to the frequency reference when the inverter is not operating and the output
frequency when the inverter is operating.
The following example shows how to configure the display items in HAND mode.
•
Monitor mode is displayed on the keypad. The output
frequency, output current, and output voltage are
displayed (factory default).
•
Go to the Config (CNF) mode. In the Config mode,
codes CNF-21
–23 are used to select the three
monitoring display items. The currently selected
display item and its setting are highlighted.
•
To view the available display items and change the
setting for the third monitoring display item, press the
[Down] key to move to CNF-23 and press the
[PROG/ENT] key.
•
The currently selected display item for CNF-23
(Monitor Line
–3) is ‗Output Voltage.‘
•
Press the [Up] or [Down] key to view the available
display items.
•
Move to ‗4 Output Power‘ and press the [PROG/ENT]
key to change the setting.