LSIS H100, Operation Manual

Page: 409 / 610

395
RS-485 Communication Features
•
When PowerOn Resume (COM-
96) is set to ‗yes‘, value is saved even if the power of the
inverter is disconnected. When PowerOn Resume (COM-
96) is set to ‗no‘, value is not
saved if the power of the inverter is disconnected.
•
A value higher than the maximum frequency (DRV-20) cannot be used. The maximum
frequency can be set by using the keypad. This value can be used when Freq Ref Src
(DRV-
07) is set to ‗Int 485‘.
•
AV2, AV3 and AV4 are used to provide acceleration/deceleration rate and frequency
reference commands. These can be written in AUTO mode only.
7.4.5.2 Multi-state Value Object Instance
Instance ID Object Name Description Setting Range Units R/W
MSV1 LostCommand
Command lost
operation setting
0: None
1: FreeRun
2: Dec
3: HoldInput
4: HoldOutput
5: LostPreset
MSG R/W
7.4.5.3 Binary Value Object Instance
Instance ID Object Name Description Active /Inactive Text R/W
BV1 StopCmd Stop command False/True R/W
BV2 RunForwardCmd Run forward command False/True R/W
BV3 RunReverseCmd Run reverse command False/True R/W
BV4 ResetFaultCmd Fault reset command False/True R/W
BV5 FreeRunStopCmd
Free run stop
command
False/True R/W
BV6 Relay1Cmd
Relay 1 On/Off
command
False/True R/W
BV7 Relay2Cmd
Relay 2 On/Off
command
False/True R/W
BV8 Relay3Cmd
Relay 3 On/Off
command
False/True R/W