LS tractor XP8084, Operator'S Manual

Page: 76 / 288

3 - 6
Vehicle speed
Tire rolling circumference
ESC main switch
ESC speed
up/down switch
ⓖ
Tire rolling circumference and Vehicle speed
 The rolling circumference of rear tire and vehicle
speed is displayed in mm/inch and km/h/mph.

Changing Unit(km/h

mph, mm

inch)
:
Press the upper side of the ESC main switch
shortly(within one second). The unit change is
only available before editing the tire rolling
circumference.

Entering edit mode
: Turn key switch to “ON”
position with pressing the upper side of the ESC
main switch. At this time, the tire rolling
circumference, “CAL”, and vehicle speed will be
displayed.

Editing tire rolling circumference
: In edit mode,
the first digit will blink at first. If pressing the
upper side of the ESC speed up/down switch,
the next digit will blink. If pressing the lower side
of the switch, the number is changed from”9” to
“0” each time you press.
 Press the upper side of the ESC main switch for
over one second, and then tire radius digits will
brink 3 times and your data will be saved. If
pressing the lower side of the ESC main switch
or turn key switch to “OFF” or “START”, your
input data will not be saved.
17 Engine torque reduction indicator
16 After-treatment system(ATS) malfunction indicator
18 DEF level warning indicator
 There is any error in the Selective Catalytic
Reduction(SCR) for reducing the NOx in the
exhausted gas. This indicator will inform you
about DEF/urea level, system malfunction, and
engine torque reduction in combination with
other indicator.
For further information, see page
3-9.
 This indicator shows the engine is going on
under engine torque reduction process due to
any SCR error.
 This indicator shows that DEF/urea level is low and the urea tank is need to be refilled soon.
Depending on the urea level, the displays is changed.
For further information, see page 3-9.
17
18
16