5 - 71
US Environmental Protection Agency (EPA) Warranty Statement
FPT Industrial S.p.A. warrants to the ultimate purchaser and each subsequent purchaser that the engine is designed, built
and equipped so as to conform with US Environmental Protection Agency (EPA) regulations applicable at the time of
manufacture and that it is free from defects in workmanship or material which would cause it not to meet these regulations
for a period of:
• 2 years or 1,500 hours of operation, whichever occurs first, for engines less than
19 kW
(
25 Hp
)
• 5 years or 3,000 hours of operation, whichever occurs first, for engines greater than or equal to
19 kW
(
25 Hp
)
NOTE: This warranty applies to all units operated in the United States or Canada.
Coverage
The model year, class of diesel engine, and emission application determination for your engine are identified on the
Emission Control Information Label. This label is affixed to one of the following areas of the engine: the top of engine's
rocker arm cover, the right-hand side of the oil pan, and the right-hand side of the engine front gear cover. The warranty
period begins on the date the new equipment is sold to the first retail purchaser. The presence of the emission control label
is the indication that the engine conforms to the applicable standards. Any emission control system parts which are proven
defective during normal use will be repaired or replaced during the warranty period.
The engine owner has responsibility to perform all the required maintenance listed in the Owner's Manual. FPT Industrial
S.p.A. will not deny an emission warranty claim solely because no record of maintenance exists; however, a claim may be
denied if failure to perform maintenance resulted in the failure of a warranted part.
It is recommended that replacement parts used for maintenance or repairs be FPT Industrial S.p.A. Service Parts to
maintain the quality originally designed into your emission certified engine. The use of non- FPT Industrial S.p.A. parts
does not invalidate the warranty on other components unless the use of such parts causes damage to warranted parts.
The manufacturer is liable for damages to other engine components caused by the failure of any warranted emission
control system part. FPT Industrial S.p.A. is not responsible for failures resulting from improper repair or the use of parts
that are not genuine FPT Industrial S.p.A. or FPT Industrial S.p.A. approved parts.
Component coverage
New engines certified for sale and registered will have the following items covered by the emission warranty, depending on
the emission level of the engine, if the items were first installed on the new engine as original equipment:
Fuel injection system
• Fuel injection pump
• Fuel injectors
• Fuel injection lines
Air induction system
• Intake manifold
• Turbocharger system (includes exhaust manifold)
• Charge air cooler
Positive Crankcase Ventilation (PCV) system (if applicable)
• PCV valve
• Oil fill cap
Exhaust after treatment Devices (if applicable)
• Diesel Oxidation Catalyst (DOC)
• Diesel Particulate Filter (DPF)
• Selective Catalytic Reduction (SCR)
• Diesel Exhaust Fluid (DEF) tank and dispensing systems
- Attachment
Summary of Contents for XP8084
