LS tractor XP8084, Operator'S Manual

Page: 213 / 288

5 - 25
▶
Do not tap the element on a
hard place when cleaning.
▶
If the element is cracked,
change it with new one.
Notice
(6) Air cleaner
①
Cleaning filter element

If the air-cleaner service indicator in the
instrument panel is turned on, make sure to
check and clean the filter element regardless of
recommended service intervals in this
maintenance chart.

Remove the cover and pull the primary element
straight out, ensuring the safety filter element
remains in place. (Fig. 1)

When cleaning the element in the working field,
tap the element by hand to remove the dust.

If the dust is not removed by tapping, use
compressed air (less than 500kPa (5bar; 72psi))
from inside to outside as shown in the right
figure (Fig. 2) to remove the dust and dirt. And,
clean inside the filter element with a clean damp
cloth.
▶
Do not assemble a wet filter element.
▶
Do not dry the wet filter element by using the compressed air. It may cause
damage to the filter element.
▶
DO NOT start the engine or close the hood if the filter element is not assembled.
Notice
< Figure-2 >
(Compressed air)
②
Filter assembly

Clean the inside of the air cleaner housing using a clean damp cloth, being careful not to damage the
safety element.

Check if there is damage inside the filter element by using a light. If there is tiny crack or small hole
in the filter element or the gasket is damaged, replace it with a new one.

Insert the filter element deeply into the filter housing.

Remove the dust of the evacuator valve and clean the inside of the cover.

Assemble the cover with the evacuator valve facing downwards.
Evacuator valve
<Figure-1>
Safety filter element
Primary element