4 - 12
DO NOT USE DIFF-LOCK
(1) Safety rules when driving tractor on the roads
When facing downhill, DO NOT place the transmission gear lever in neutral position.
When driving the tractor on an unpaved road with a heavy rear implement on the 3-point linkage, do
not drive fast and do not lift up the implement to the highest position. The hydraulic lift system may
be damaged by vibration and impact. In this case, place the position control lever on the 3/4 rising
position of the full stroke and select an appropriate driving speed before entering the unpaved road.
4-4. Transport on public roads
▶
Connect the left/right brake pedals with the brake pedal latch before driving.
▶
Avoid a sudden start, sudden brake and sharp turning.
▶
DO NOT allow people on the tractor or other implement.
▶
DO NOT place baggage on the tractor or other implement.
▶
Place the PTO gear lever in neutral position and put the PTO switch in the “OFF”
position.
▶
DO NOT use the differential lock pedal and front wheel drive(4WD) on the road.
▶
When traveling with a implement on the rear 3-point linkage, tighten the stabilizers
to avoid lateral movement.
▶
When traveling with a long and heavy implement, turn slowly with a wide turning
radius.
▶
While traveling on public roads, do not ride your foot on the clutch pedal or brake
pedals, do not operate any implement such as tiller, loader and etc.
▶
When traveling or starting the tractor on an uphill, select the range shift gear
lever and main gear shift lever properly not to damage the engine and
transmission drive line. If not, especially for the power shuttle / power shift
models, it may cause damage to the power shuttle clutch by excessive
abrasion.
Caution
Summary of Contents for XP8084
