LS tractor XP8084, Operator'S Manual

Page: 221 / 288

5 - 33
(1) Replacing Hydraulic Oil Filter

Park tractor on level surface and apply parking
brake and lower implements and stop the engine.

The filter is located in front of the left rear axle
housing.

Carefully clean around the filter and set a clean
container under the filter.

Coat clean hydraulic oil on the packing of new
filter and check the packing is placed well in the
groove.

Turn the oil filter counter-clockwise to remove
with filter wrench.
Power shuttle
oil filter
(2) Replacing Power shuttle oil
filter (power shuttle models only)

This filter is attached under the right-hand step
floor of the power shuttle models.

Replace this filter with a new one to the same as
procedure of the hydraulic oil filter.
5-8. Every 300 hour check
Hydraulic oil filter
▶
Make sure to stop the engine before loosening the oil filter.
▶
If the filter or oil is very hot, it may cause serious burns. After cooling down the
tractor sufficiently, replace the filter.
▶
Do not throw the exhausted waste oil to any place. This may pollute the soil and
water seriously and also is prohibited legally. If violating, you would be responsible
for that by civil or criminal case.
Warning

Turn the new filter clockwise to assemble until the packing makes contact with the mounting surface.
Tighten ¾ to 1 turn more after packing contact.

Run the engine at idle and check any leakage.

Check the oil level. If necessary, add new oil. For oil specification, see chapter 5-3, “Lubricants and
Capacity” or the last page in this manual.