LMI Technologies Gocator 2100 Series, User Manual

Page: 57 / 523

Gocator Line Profile Sensors - User Manual
Gocator Web Interface • User Interface Overview • 57
multiple job files. If there is a job file that is designated as the default, it will be loaded automatically
when the sensor is reset.
When you change sensor settings using the Gocator web interface in the emulator, some changes are
saved automatically, while other changes are temporary until you save them manually. The following
table lists the types of information that can be saved in a sensor.
Setting Type Behavior
Job Most of the settings that can be changed in the Gocator's web interface, such as the ones
in the
Manage
,
Measure
, and
Output
pages, are temporary until saved in a job file.
Each sensor can have multiple job files. If there is a job file that is designated as the
default, it will be loaded automatically when the sensor is reset.
Alignment
Alignment can either be fixed or dynamic, as controlled by the
Alignment Reference
setting in
Motion and Alignment
in the
Manage
page.
Alignment is saved automatically at the end of the alignment procedure when
Alignment Reference
is set to
Fixed
. When
Alignment Reference
is set to
Dynamic , however, you must manually save the job to save alignment.
Network Address Network address changes are saved when you click the
Save
button in
Networking
on
the
Manage
page. The sensor must be reset before changes take effect.
The job drop-down list in the toolbar shows the jobs stored in the sensor. The job that is currently active
is listed at the top. The job name will be marked with "[unsaved]" to indicate any unsaved changes.
To create a job:
1. Choose [New] in the job drop-down list and type a name for the job.
2. Click the Save button or press Enter to save the job.
The job is saved to sensor storage using the name you provided. Saving a job automatically sets it as
the default, that is, the job loaded when then sensor is restarted.
To save a job:
l
Click the Save button .
The job is saved to sensor storage. Saving a job automatically sets it as the default, that is, the job
loaded when then sensor is restarted.
To load (switch) jobs:
l
Select an existing file name in the job drop-down list.
The job is activated. If there are any unsaved changes in the current job, you will be asked whether you want
to discard those changes.