Ø65
Ø65
More than 200
More than
100
More than 2300
More than
100
(Unit : mm)
Ø65
Installation Plate
Ø65
Installation Plate
Installation Plate
Chassis
Hook
Type "A" Screws
Ø65
Ø65
Ø65
Installation Plate
Ø65
Installation Plate
Installation Plate
Type "A" screw
Chassis
Hook
10.1 Selection of the best location
• There should not be any heat or steam near the unit.
• Select a place where there are no obstacles around of
the unit.
• Make sure that condensation drainage can be conve-
niently routed away.
• Do not install near a doorway.
• Ensure that the interval between a wall and the left (or
right) of the unit is more than 100mm. The unit should
be installed as high as possible on the wall, allowing a
minimum of 200mm from ceiling.
• Use a metal detector to locate studs to prevent unnec-
essary damage to the wall.
Fixing Installation Plate
The wall you select should be strong and solid enough to
prevent vibration
• Mount the installation plate on the wall with type "A"
screws. If mounting the unit on a concrete wall, use
anchor bolts.
- Mount the installation plate horizontally by aligning the
centerline using Horizontal meter .
• Measure the wall and mark the centerline. It is also
important to use caution concerning the location of the
installation plate. Routing of the wiring to power outlets
is through the walls typically. Drilling the hole through
the wall for piping connections must be done safely.
28
_
Wall Mounted Unit (Standard)
Indoor unit
10. Installation
Indoor Units