148
7. Connect the power supply wiring harness to the power connector on the
motherboard.
8. Place the power supply onto the chassis.
Be sure all of the screw holes line up.
9. Gently push the power supply wiring harness into the chassis.
Be sure to route the wires are away from metal edges.
10. Install the screw attaching the power supply to the Network Storage
chassis, inside near the wiring harness.
11. Install the three screws that attach the power supply to the back panel.
One screw is beside the power connector, two screws are beside the
power supply fan.
Reassemble the enclosure
1. Place the bottom panel onto the Network Storage chassis.
The bottom panel locks under the front (disk drive end) panel.
2. Place the black side panel beside the Network Storage chassis and slide it
into place.
3. Place the silver side panel onto the chassis.
The silver panel snaps into place.
4. Install the five screws that attach the bottom of the enclosure.
5. Turn the enclosure over and place it on its feet.
6. Reconnect the fan power harness to its connector on the motherboard.
7. Place the back panel onto the enclosure and install the four screws to
attach the back panel to the enclosure.
