146
Remove and Replace the Fan
1. Remove the four screws on the back of the enclosure.
2. Carefully remove the back panel from the enclosure.
3. Disconnect the fan power harness from its connector on the motherboard.
4. Gently pull the two retainer clips away from the cooling fan.
5. Lift the cooling fan off the locating pins.
6. Check the direction arrow on the new fan to be sure it blows outward.
7. Align the new fan with the locating pins on the back panel and gently press
the fan into place on the panel.
The fan snaps into place between the retainer clips.
8. Reconnect the fan power harness to its connector on the motherboard.
9. Place the back panel onto the enclosure and install the four screws to
attach the back panel to the enclosure.
Reconnect and Power-up
1. Reconnect the power cord, network cable, and USB cable.
2. Press the Power Button on the front of the Network Storage (right).
When the Network Storage is fully booted:
•
The System Status LED turns green
•
The buzzer beeps one time (if the buzzer
is enabled)
Important
See “Connection Problems After Restart”
System
Status LED
Power
Button
