Display and control panel
Leuze electronic
LES 36
57
TNT
35/7-2
4
V
Note!
If no button is pressed for three minutes, the LES exits menu mode and switches to measure
mode. The OLED display again displays the alignment aid and the sensor status display.
Note!
After changing the PROFIBUS slave address, a power-on reset must be performed in order
to permanently accept the address.
Serial No.
01408004336
Sensor serial number
Ext. Info
K000
Leuze-internal information
Software
V01.50
Software version of the sensor
Part no.
Return to menu level 1
Menu Exit
Select Insp. Task
Exit menu and return to measure mode
1)
The inspection tasks can be switched via the control panel.
2)
The setting of the active inspection task applies only if "Ext. Selection" = "Disabled"
3)
The application settings apply for the currently selected inspection task. Individual application settings
can be made for each task.
4)
With "Manual Settings", the value preset via LRSsoft is used.
5)
This menu item exists only with the PROFIBUS device versions.
6)
The values configured here are not applied immediately but only when the sensor is switched on the
next time.
Level 1
Level 2
Level 3
Level 4
Explanation / Notes
Default
Table 7.2:
Menu structure
