Leach 2R-III, Maintenance Manual

Page: 129 / 168

Service & Repair 119
N
OTE
:
If you only need to replace worn-out chromium plates, you will have some unwelding and
rewelding to do. But before doing so, take all the necessary measures to ensure your safety.
4 f.
Check the track bar for cracks and wear.
4 g.
Install a new wear shoe where the old one was mounted.
In cases where a complete wear shoe had to be removed.
4 h.
Lower the packer and carrier panel assembly completely.
4 i.
Reinstall the pin.
Take the screw off the pin if you have not already done so.
4 j.
Place the plastic plates back into the wear shoe assembly.
4 k.
Put the screws back into the plate holes.
5.
If need be, repeat step 4 if other wear shoes need to be replaced.
Remove one wear shoe at a time.
Figure 8-2 Wear shoe assembly
6.
If shims were used, put them back inside the new wear shoe assembly.
Pin
Plastic
plates
Screw
Top
chromium
plate
Bottom
chromium
plate
If needed,
shims (part
#186536) are
placed here