PAGE 66
6.
Next take off the outer left stride cover. You will need to drill out holes for the cable & power
connector’s. Measure 3 ½ inches from the bottom of the stride cover, in line with the bottom left
hole for the mounting screw, and mark it with a pencil to drill your hole. Use a 6/32 drill bit as a
starter hole. Then drill it out using a 3/8
th
’s drill bit.
7.
Now measure 2 ½ inches from the bottom of the stride cover, in line with the bottom left hole for the
mounting screw and mark it with a pencil to drill your hole. Use a 6/32 drill bit as a starter hole.
Then drill it out using a ½ drill bit. Refer to the picture below for steps 6 & 7.
8.
Remount the stride cover back onto the elliptimill and make your connections. Turn the LVS DVD
player on and test it out.
3.5 inches
from
bottom
(3/8 hole)
Cable
connector
2.5 inches
from
bottom (½
hole).
Power
connector
Summary of Contents for ELLIPTIMILL E8
