PAGE 60
DISPLAY LIGHTS UP, START TO USE THE MACHINE BUT
THERE IS NO SPEED FEEDBACK IN SPEED WINDOW.
Take off the cover at the front of the
machine and the left outside frame
cover. Locate the speed sensor at the
bottom right hand side of frame by
the drive wheel. Then check the gap
of the sensor.
Is it out of position?
YES
Adjust sensor:
1.
Loosen phillips
head screw that
holds sensor in
place.
2.
Adjust gap to
3/8
th
of an inch.
3.
Tighten phillips
head screw.
NO
YES
If found on harness end,
replace the harness. If
found on sensor end
then replace the speed
sensor.
NO
NO
Replace speed sensor.
YES
Check the main wire
harness going to the
display.
Any loose
wires found?
Replace Upper Board.
NO
YES
Replace wire
harness
Unplug the speed sensor from
harness and check for loose wires.
Any found?
Spin the drive wheel by hand and
check on the relay board to see if the
YELLOW SPEED LED
flickers.
Does the SPEED LED flicker?
Summary of Contents for ELLIPTIMILL E8
