STEP 5
Using a
6mm
allen socket loosen and remove the
drive pulley bolt
STEP 6
Remove the drive pulley from the elliptical
STEP 7
Using a hammer and a flat head set punch knock out
the bearings on either side of the elliptical
STEP 8
Using a fine grit piece of sandpaper clean off any
residue left in the hub of the elliptical
Apply a little grease on the hub of the elliptical
and bearing
STEP 9
Using a hammer gently tap both bearing in place on
either side of the elliptical
STEP 10
Using a clamp and two pieces of wood press the
bearings back into place
NOTE: FOLLOW THE STEPS IN REVERSE TO REASSEMBLE THE
ELLIPTICAL
PLEASE CALL LANDICE TECHNICAL SERVICE 1-800-526-3423
Summary of Contents for ELLIPTIMILL E8
