Landice ELLIPTIMILL E8, Service Manual

Page: 17 / 68

9. Pick up the
upright assembly
and walk it into the
frame from the rear
in as shown in the
picture. 10. Carefully
rotate the upright
legs into the
correct alignment
and slip them into
their respective
black fittings on top
of the frame. Once
in, you can remove
the protective
cardboard and the
plastic wrap / foam
that secures the
arms together
(arrow pointing to it
in picture).
11. Open
hardware bag
"STEP 2".
Commence, but do
not tighten all the
screws with
washers on each
upright using the
smaller allen key
(12 per side). You
will tighten them
later. 12. Using the rest
of the screws in the
the hardware bag
"STEP 1", discard
the protection caps
and firmly fasten
the moving hand
rails using the
bigger allen key.
NOTE: There is a
difference between
right and left ("L" /
"R" decals).
PAGE 17