PAGE 56
The relay board is designed with diagnostic LED lights. The LED’s are color coded according
to their specific function. Green indicates should always be ON when power is supplied to the
elliptical. Here is a list of each LED and whit it signifies:
+12V (green) –
The +12V LED illuminates when DC voltage is being supplied to the relay
board. The power pack takes the AC voltage from the wall, converts it to DC voltage and sends
it to the relay board.
BSW+ & BSW- (red) –
These LED’s tell you if the upper board is sending a signal to close
the relays on the board. When the LED lights, it tells you that the coil on the relay is being
energized.
MTR+ & MTR- (red) –
These LED’s illuminate when DC voltage is being supplied to the
brake motor. When this LED lights, it tells us that the relay has energized and sending DC
voltage to the brake motor.
SPEED (yellow) –
The speed LED flashes on and off (relative to rotation of the drive pulley)
when the speed sensor is operating properly.
LED CONFIGURATIONS: RELAY BOARD
Summary of Contents for ELLIPTIMILL E8
