Landice ELLIPTIMILL E8, Service Manual

Page: 50 / 68

PAGE 50
CRANK ARM (Removal):
1. Take the set screw out for the adjustment knob completely out and then remove
the adjustment knob by turning it counterclockwise.
2. Remove the red handle by turning it counterclockwise.
3. Take out all the phillips head screws for the stride adjustment cover. (See Figure
A)
4. Remove (4) #6 Socket Head Caps screws at the bottom where crank arm meets
the crank.
(Figure A)
CRANK ARM (Install):
1. Follow the reverse of removal instructions to install new crank arm but don’t
install the stride adjustment cover.
2. To set up crank arm:
a) Tighten the red handle at the top of the assembly. Then turn the red
handle counterclockwise 5.5 turns.
b) Rotate the crank assembly and watch the top of the crank to see if it hits
up against the red handle and stride bar (See Figure B).
c) If not or little movement then tighten the red handle down and proceed to
step d. If it hits both sides then you will have to replace the crank arm.
d) Install stride adjustment cover.
e) Install stride adjustment knob and then set screw.
(Figure B)
REMOVAL AND REPLACEMENT OF COMPONENTS
Screws are
on backside
Screws for
front side
Step b is to check the
deflection by 5mm. If
it hits both sides then
crank arm is bad.
5mm
deflection