Landice ELLIPTIMILL E8, Service Manual

Page: 22 / 68

PAGE 22
E-SERIES DCP ASSEMBLY INSTRUCTIONS
1. Feed the
upright harness
(found in
membrane box)
down the leg.
Slide it all the way
down until you
can grab it at the
base of the
machine through
the access hole.
TIP: Once you
grab the harness
at the base, make
sure to clip in the
harness at the top
of the upright to
prevent it from
falling down
inadvertently.
2. Clip the
harness to the (2)
harness clips
along the frame.
Once you have
secured the
harness to the
clips, connect it to
the female
connector on the
lower electronic
board.
3. Place the
membrane in the
control panel and
connect the two
harnesses coming
from the contact
hand grips to the
smaller board
located on the far
side of the
membrane. The
white connectors
can go on either of
the two available
3-pin connectors.
4. Connect the
upper harness to
the upper board.
Center the
membrane and
pitch it back into
place so that the
velcro mates
securely. Connect
the
main power
cord to the front
cover so
you can
turn the machine
and verify all
electrical
connections.