PAGE 65
LVS2 RETROFIT INSTRUCTIONS
TOOLS NEEDED:
•
6/32 drill bit (starter bit).
•
3/8
th
drill bit.
•
½ inch drill bit.
•
Tape measure, ruler, or t-square.
•
Drill
•
Fine grit sand paper to remove burr’s.
1.
Take the upright end caps and upper console off of the control panel.
2.
Measure 1 inch from the left side of the control panel and mark it with a pencil to drill your hole.
3.
Drill in the center using a 6/32 drill bit. Then drill the hole bigger using a ½ inch drill bit.
4.
Now that you drilled out your access hole for the cable and power wires, clean of any burr’s from the
hole using fine grit sandpaper and run your wires thru.
5.
After fishing the wires thru the access hole, slide them thru the left side upright. They will come out
thru the u cut out at the bottom of the upright. (See pictures below).
1 inch from
left side.
Summary of Contents for ELLIPTIMILL E8
