17.2)
PARAMETERS SETTING
In this section the display describes the type of selected parameter;
push button F1 decreases the setting value in percentage;
push button F3 increases the setting value in percentage; push
button
allows proceeding to the following parameter; push
button F2 allows returning to the previous parameter;
Here the explanation of each single parameter.
PARAMETER
Ref. Drawing
DESCRIPTION
*'SLAVE
P01
Fig.1
Opening speed.
Increase this value for a faster door opening speed.
S
P02
Fig.2
Closing speed.
Increase this value for a faster door closing speed.
S
Safety sensor, slow motion area in opening.
When the door leaf at the end of the opening is close to the wall, the safety sensor in
P03
Fig.4
opening can detect it and stop the door. To prevent an uncomplete opening cycle the
S
door can moving at low speed when the sensor detect the wall. The area from where the
door reacts with a low speed instead of stop depend from this potentiometer. If P03=0
the door stop ever, increasing the value the door use low speed to approach the end of
the opening. At maximum value the area start from about 45° from the end of opening.
P04
Thrust power during opening.
Increase this value for higher motor thrust power
S
during opening (and closing if set closing by motor) cycle.
P05
Pause time,
can be regulated between 0 and 60 seconds. It is the time in which the
door remains open before closing.
P06
Closing voltage at door closed.
Increase this value to keep the motor thrust active
S
with door close.
Wind stop function at door closed.
At 0% (default value) the function is disabled.
P07
Fig.5
Increasing this value the motor is applying an opposite force to wind strength in order to
S
keep the door leaf closed.
P08
Fig.3
Push & go.
At 0% (default value) the function is disabled. Distance from where a door
S
pushed by hand start to open automatically. Setting range between 2° and 15°.
P09
Final thrust for electric lock coupling
(active if
F04=ON
). Increase this value for a
S
higher leaf speed in the last closing phase so that an easier coupling to electric lock is
enabled.
31
Summary of Contents for Vista SMP
Page 56: ...VISTA SMP Made in UK ...