Label Vista SMP, Installation Manual

Page: 11 / 56

6.3 Cut out mounting cradle
– installation steps
Step 1: Place cradle in cut out in floor with the pivot point hole nearest the hinge side of the door.
Step 2: Plumb down from the top pivot and ensure the pivot point hole of the cradle is aligned.
Step 3: Fix the cradle into place via the two positioning slotted holes using countersunk screws (screw length to be
determined by installer). This will allow a slight movement and offer a final adjustment to align the floor unit with the centre
line of the door and also align the pivot point with the top centre.
Step 4: Fix the cradle via the four fixing holes using countersunk screws (screw length to be determined by installer to offer
secure fixing). Remove the screw from the slotted holes.
Step 5: Place the motor unit into the cradle locating the threads into the slots on the side of the cradle.
Step 6: Secure motor unit into place by tightening nuts on threads.
Step 7: Make good, by filling in void around floor units with concrete/cement
Cement box end
view
Floor cut out
Cut out mounting
cradle
Motor box
Caution: For correct installation it is essential :

The top of the steel primary cover is mounted exactly flush with FFL.

The box is aligned exactly parallel to the door opening.

The box is positioned to match that of the door pivot.

The box is firmly secured in position.

The box is protected from damage

Debris prevented from entering the conduit ends.

Door stops at 0 degree & fully open position are fitted to prevent
damage to drive
11