SKY899
Installation Manual
Page 2-36 - Installation
009-11900-001
July 18, 2013
Revision F
Figure 2-13: Mounting Holes for Ruggedized Mounting Tray, P/N 805-10870-003
2.27 TRC INSTALLATION
CAUTION
Before placing the TRC into its mounting tray, de-energize or disconnect
all power and signal sources and loads used with the SKY899 system.
1.
Slide the TRC into the mounting tray (see Figure 2-14). Ensure that the rear hold-down pins on the
mounting tray are properly inserted into receptacles on the TRC.
2.
Place the retainer cups over the TRC J-hooks. Secure the TRC to the mounting tray by tightening the
self-locking hold-down knobs.
3.
Connect the three antenna inputs to the connectors on the front panel.
4.
Connect the Sum port antenna connector (P9 - a TNC connector identified with a blue band) to
connector J9 (identified with blue marking).
5.
Connect the Probe (Bit) port antenna connector (P10 - a BNC connector identified with a black band)
to connector J10.
6.
Connect the Difference (Delta) port antenna connector (P11 - a TNC connector identified with a red
band) to connector J11 (identified with red marking).
7.
Connect I/O Signal Cable (P1 - a 100-pin connector) to connector J1.
8.
Connect the power cable (P8 - a three-pin connector) to connector J8.
The document reference is online, please check the correspondence between the online documentation and the printed version.