SKY899
Installation Manual
009-11900-001
Appendix H - Page H-3
Revision F
July 18, 2013
5.
Using the NEXT PARAM and PREV PARAM softkeys to select on-screen functions, set each
parameter as shown in Table H-1.
Table H-1: TCAS Setup Page Parameters
Function
Parameter
Notes
RF Port
ANTENNA
ANT RANGE
(Variable)
Determine the distance from the test set position and
the aircraft’s directional antenna. Enter this value.
(Figure H-4: Test Position Setup, Item B).
ANT HEIGHT
(Variable)
Determine the height difference between the Test Set
Antenna and the aircraft directional antenna (Figure
H-4: Item A). Enter this value
UTT ADDRESS
AUTO
MANUAL AA
Not used
If test set antenna is detached and connected to the
test set using the long RF coaxial cable, enter the
cable loss value (in dB) marked on the test set’s long
RF coaxial cable.
DIR CABLE
LOSS
Not Required
If test set antenna is detached and connected to the
test set using the long RF coaxial cable, enter the
cable loss value (in dB) marked on the test set’s long
RF coaxial cable.
ANT CABLE
1 ft.
If test set antenna is detached and connected to the
test set using the long RF coaxial cable, enter length
of long RF coaxial cable.
ANT CABLE
LOSS
(Variable)
Entered in dB, loss value is marked on the test set’s
short RF coaxial cable.
ANT GAIN
(Variable)
Entered in dBi, gain values (0.0 to 20.9) for 1.03 and
1.096 GHz marked on supplied Test Set Directional
Antenna.
SQUITTERS
ON
ALT REPORTING
ON
DISPLAYED ALT
RELATIVE
TEST SET AA
Not Required
NOTE
Do not exceed 250 feet. Exceeding 250 feet may result in inconsistent
replies. If any interference is observed, reduce the distance between the
IFR-6000 and the aircraft directional antenna.
Figure H-4: Test Position Setup
The document reference is online, please check the correspondence between the online documentation and the printed version.