SKY899
Installation Manual
009-11900-001
Appendix F - Page F-3
Revision F
July 18, 2013
NOTE
After power up, it may take a couple of minutes for the altitude encoder
to return a valid altitude to the transponder and SKY899.
3.
Turn SKY899 ON.
4.
Verify start up screen, similar to one shown in Figure F-2, is displayed on the terminal device.
Welcome to the L-3 Avionics Systems SKYWATCH HP
Copyright (c) 2003 L-3 Avionics Systems, Inc.
All rights reserved
Figure F-2: Startup Screen on Terminal Device
NOTE
Until the system setup and antenna calibration procedures have been
completed the display may show "fail" messages. If the messages do not
go away after system setup and calibration, refer to the troubleshooting
section in paragraph 4.5.
F.3.1 System Setup
1.
At the terminal device, enter the Service Menu by typing Menu <Enter>.
Service Menu
1 Setup
2 Information
3 Calibration
4 Ground Test
5 Configuration Management
x Exit
Choice:
NOTE
The service menu displayed on the terminal device is similar to the one
seen in Chapter 4, except each command has a prefix. To select a menu
item type the prefix <Enter> (i.e., 1 <Enter>, 2 <Enter>, x <Enter>, etc.).
2.
From the Service Menu, select Setup (1 <Enter>).
The document reference is online, please check the correspondence between the online documentation and the printed version.