3JF
1-2-2
Turn the machine's power switch to OFF and unplug the machine from the power supply before installing the fax system.
<Procedure>
Install the optional Memory module DIMM (32MB).
1. Remove the two connectors of the fax control PCB assembly.
2. Remove the three screws and remove the mounting plate and the
ground wire.
Figure 1-2-2
Figure 1-2-3
3. Insert the memory module DIMM at an angle into the memory slot so that the notch of the memory DIMM is
positioned to the projection of the memory slot on the fax control PCB assembly. (
1
)
4. Push the free end of the module down toward the board. (
2
)
5. Attach the mounting plate and the ground wire that have been removed by Procedure 2 with the three screws to their
original positions.
6. Connect the two connectors that have been removed by Procedure 1.
Screws
Fax control PCB assembly
Mounting plate
Connectors
Ground wire
Memory module DIMM
Notch
Memory module DIMM
Memory module DIMM
Memory slot
Memory slot
Projection
Memory slot
Fax control PCB assembly
