Kval MLX, Operation And Service Manual

Page: 53 / 144

About the Main Control Screen
2-23
KVAL MLX Operation/Service Manual
Start Sequence
After templates and programs are loaded, the doors are in place to process, the
machines is homed, Press the Start Sequence button to run the machine line.
Note:
Pressing the
Door Stop Pedal
will perform the same operation as the
Start
Sequence
Edge Toggle
This button adds the flexibility to override the sequence and select the edge position.
This button also allows the opportunity to repeat the selected cut.
This control is also located at the machine control panel as a mechanical switch (but
-
ton)
Door Finished
Clears the job if user wants to finish before completing all cuts, or at the end of the a
portion of the Door Job.
About the Stop and Clamp Control Section
Clamp and Door Stop control is accessed at this section.
Toggle Clamp
Press to toggle the door clamps UP or DOWN. This button is only available when
a
job is loaded in the machine.
Toggle Door Stop
Press to toggle the door stops UP or DOWN. This button is only available when
a job
is loaded in the machine.
Manual Stop Location
The movable stop location is displayed here.
The value is determined by the
KvalCAM
Door Job.
Move the stop to the displayed
value. See “Step 4: Set the Movable Stop” on
page 2-13. After the stop is moved, select
the
Confirm Door Stop Moved
button