Kval MLX, Operation And Service Manual

Page: 77 / 144

Step 2: Calibrate the Carriage Axis
KVAL Operation Manual
3-13
Step 2: Calibrate the Carriage Axis
This section describes the method to calibrate the carriage axes for the edge and the face tooling
set.
At the
Calibration Screen
, select
Carriage Axes.
Select the desired
Axis
to make adjustments.
Process to Calibrate the Carriage Head
In this calibration, process a known good square on the edge of the door. Measure the
location
of
the square.
1.
Before calibrating the tools, update or check the
Tool Configuration
of the tool being cal
-
ibrated. See “About the Tool Config Tabs” on page 2-26.
2.
Create a Edge Rectangle
Door Job
of your choice.
3.
Add
Door Job
to the
Queue
.
4.
Once the cut has been made, check the location of the cut.
5.
Perform the Left Hand Rule at the edge of the door to determine axis direction. See illus
-
tration on the next page.
• If the location is out of specification in the
length
of the door, the
X-Axis
needs to
be adjusted.
• If the location is out of specification in the
width
of the door, the
Y-Axis
needs to be
adjusted.
• If the plunge cut is out of specification, check the
Configuration Menu
then verify
the
Z-Axis.
6.
If not in specification, adjust the location. Repeat until specification is reached.