Kval MLX, Operation And Service Manual

Page: 112 / 144

How to Access to Bit Assemblies
KVAL MLX Operation/Service Manual
5-22
3.
Lightly attach collet assembly on drill.
4.
Insert the new bit into the assembly.
5.
Before tightening the collet assembly, adjust the bit depth to the measurement taken
in step 1. Ensure there is a minimum of 1/8” clearance from the end of the bit to the
bottom of the tool holder.
6.
Tighten the collet assembly.
7.
Inspect and verify the work. Clean the work area.
Remove and Replace the Router or Pre-Drill Bits
Caution:
Before performing this process, turn off all power to the machine. Follow
proper Lockout/Tagout procedures as detailed in the safety section of Chap
-
ter 1 of this manual.
1.
Use a 17 mm shaft wrench and a 3/8 “collet wrench to remove the bit on the pre-drill
or router assemblies. See Figure below .
FIGURE 5-3.
Removing Pre-Drill or Router Bit.
2.
Inspect and clean collet assembly.
\
\