Kurzweil K2500RS, Musician'S Manual

Page: 154 / 530

Song Mode
MISC Page
12-20
Loop - The Loop PlayMode will loop the current Song from the End point back to Bar 1, Beat 1
continually during playback until Stop is pressed.
List - Song Objects in memory can be played back to back in numerical ID# order starting from
the current Song followed by the Song with the next highest ID#. Once the current Song reaches
its End point, immediately the CurSong parameter is updated to the next highest Song Object
ID# and it will play from Bar 1, Beat 1 to its End point. When the Song with the highest ID# in
memory has played through to its End point, the sequencer will stop and that Song will be the
new ÒCurSongÓ.
Chain - For every Song, there is a parameter called ChainTo found on the COMMON page that
determines what other Song, if any, will immediately follow this SongÕs playback when
PlayMode is set to Chain. When the current song ends, the ChainTo Song will replace the
previous CurSong, and if its ChainTo parameter is set to any value other than "0 None", then
the Chain PlayMode will continue playback with the next Song being chained. When the last
Song in the chain has played through to its End point, the sequencer will stop and that Song
will be the new CurSong.
The most common use for the Chain PlayMode is to construct a Set List of different Songs.
Since the Songs chained together are played immediately after one another, it is recommended
that you include a few measures of silence either at the end or the beginning of each Song in the
Chain.
KeyWait
KeyWait speciÞes whether the sequencer will wait for a Note event before going into PLAYING
or RECORDING status. With the KeyWait On, press the
Play soft button while the sequencer is
STOPPED or REC READY and the new status, KEY WAIT, will ßash in the Song Status Field
until a key is played. You can override the KEY WAIT status by pressing the
Play soft button
twice.
Locate
The Locate Bar and Beat will change in real time during play back and recording to reßect the
SongÕs current position. It can be set to a Bar and Beat before (negative values) or during a
Song. Once a SongÕs length is deÞned, the End point is the maximum value for the Locate
parameter. If Locate is not set to 1 : 1, the count off, if any, is disabled during play back or
recording.
This parameter is identical to the Locate parameter on the MAIN page.
AutoIn
When you are in Auto record mode, AutoIn is the Bar and Beat when the recording will begin.
If AutoIn is not set to 1 : 1, the count off, if any, is disabled. The AutoIn setting will not have an
effect on recording unless the RecMode is set to Auto.
AutoOut
When you are in Auto record mode, AutoOut is the Bar and Beat when the recording will stop.
Set the AutoOut location earlier than the Bar and Beat deÞned as the AutoIn point in order to
record to the very end of a Song. The AutoOut setting will not have an effect on recording
unless the RecMode is set to Auto.
Input Quantize (Quant)
This parameter determines how much Note events are moved towards grid locations upon the
initial input of the events. If set to Off, no Quantizing will occur while you record, and the exact
timing of your performance will be preserved during play back. If set to 100%, every recorded
Note event will be aligned to the closest grid location, deÞned by the Grid setting. Input