Kurzweil K2500RS, Musician'S Manual

Page: 246 / 530

Disk Mode
Disk Utilities
13-60
A good way to organize Þles into subdirectories, with a disk drive that was being used with
previous versions of K2vx software, is by using the Move command. First, create the
subdirectories you need, using the
NewDir function. Then, use multiple Þle selection to select
the Þles to be grouped into a particular subdirectory. The Þles can be moved to their new
location in one operation.
For each Þle that is moved, you will see a conÞrmation message:
\ATOMTOM.KRZ|moved|to|||||||||||||||||||
\DRUMHITS\ATOMTOM.KRZ
Note the following:
•
You can select multiple Þles for moving within a directory. However, you cannot move
Þles from more than one directory at a time. If you select any Þles and then switch to
another directory, the Þles you had chosen will be deselected.
•
If you are moving a directory, you cannot move it in to a subdirectory of itself.
•
If the source and destination directories are the same, the Þle will not be moved, and an
error message such as the one below is displayed. This would happen if you pressed
Current above.
•
The same message will be displayed if there is a Þle in the destination directory with the
same name as the Þle to be moved.
File|\ATOMTOM.KRZ|not|moved.||||||||||||
Renaming Files
Press the Rename soft button (from Disk Mode) to rename Þles or directories without loading
them. When you press Rename , the K2vx will prompt you to select the Þle to be changed, by
showing you a list of the Þles found on the current disk.
When youÕve selected the Þle to be renamed, press OK , and the K2vx will ask you to enter the
new Þle name. When youÕve done this, press OK , and the Þle name will be changed.
Dir:\||||||||||||Sel:0/1|||||Index:|||1|
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||
|||||||||||||||||||||||
||File|to|rename: FILE9876|.KRZ|||2048K||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Total:
2048K| | |||||| | |||||| | ||||| | ||||||
||||||| |Root| | Parent | |Open| | |OK|| | Cancel
This function can only be used to change the 8-character Þle name and not the extension. When
you press
Rename , the File List dialog is displayed and you can navigate through the
directories to choose the Þle or directory you wish to rename. Unlike the other disk functions
that use the File List dialog, you will not see the
Select soft button. This is because you can only
rename one Þle at a time. Therefore you simply choose the Þle you want and press OK . The
K2vx will then ask you to enter a new name. Once you've done this, press OK again, and the
Þle name will be changed.