KUHN IND 360P, Maintenance Manual, Page: 7 / 54

7
1.3.2 MACHINES WITHOUT CHASSIS
Type of machine: ALTOR 4560, 6070, 7560 and 8060
ATHENOR 6070, 7560 and 8060
ALTOR and ATHENOR 4560, 6070 & 7560
Before responding to the message ‘Is the machine empty?’ (IND360) or “--0--” (IND900), ensure
that:
- The tractor engine is switched off.
- The machine is horizontal lengthways and widthways at the transport height; if not, refer to the
section on technical characteristics and tow bar adjustment in the user instructions.
- The machine is not exposed to strong wind.
- The transmission slides effortlessly.
- The machine’s components (arm, grab and tailgate) are in the idle position (see user instructions).
- The brakes are off (parking and service brake) (see user instructions).
Sufficient clearance is required between the brake shoes and the drum;
any rubbing may cause incorrect weighing.
Adjusting the levelling sensor
- Set the body to height B from the ground and the towing eye bolt to height A, adjust the screw (1) to
position it opposite the sensor, then set the detection distance to approximately 3 mm (maximum
4 mm). The sensor indicator should then light up.
- Tighten the screw and the sensor onto their respective mountings.
- Check the body height setting. To do this, lower the body to the ground, then raise it until the indicator
lights up and measure the body height. This must be equal to height B ± 10 mm.
If the measured distance is not correct, repeat the adjustment operation.