49
6 - ENTRETIEN
Recommendations
Before carrying out any maintenance or repair work or when attempting
to find the cause of a fault or malfunction, switch off the engine, lay the
machine on the ground, remove the key from the ignition and wait until
all moving parts have come to a complete standstill.
Before proceeding with maintenance work on a machine in the raised
position, prop it up with an appropriate support.
Before carrying out any work on the weighing unit, disconnect the
electrical circuit from the unit.
Never remove the front panel from the IND900 unit.
Check regularly that the weighing unit is watertight (seals, gland, front
panel sticker, etc.).
Check the condition of the power cables and sensors regularly
(protective sleeves flattened or cut) and change them if necessary.
WARNING
To carry out welding work on a machine, disconnect the electrical power
supply from the machine and the tractor (battery or alternator).
Connect the earth lead as close as possible to the part to be welded.
Never connect the earth to the chassis to weld the body and vice-versa.
If this advice is ignored, then irreparable damage can be caused to the
sensors linking the body to the chassis.
We strongly advise against the use of pressure washers. There is a
risk that moisture will penetrate inside the weighing unit and sensors.
6.
MAINTENANCE
Summary of Contents for IND 360P
Page 23: ...23 NOTES ...
Page 50: ...50 NOTES ...