KUHN IND 360P, Maintenance Manual, Page: 44 / 54

44
Before fitting a sensor, grease the gasket, the mounting hole and the sensor.
- Take the new sensor and feed the wire through the sensor holder.
- Fit the sensor with the cable on the right when viewing from the cable side.
If the sensor is fitted the wrong way round, the weight indicated will be
incorrect.
Fitting from the outside
- Put the sensor in its housing. Be careful not to damage the wire.
- Using the mallet, tap the sensor in and fit the gasket in the fork of the holder.
Fitting from the inside
- Put the sensor in its housing.
- Fit the gasket in the fork of the holder.
- Screw the slide hammer onto the sensor then pull the gasket and sensor into place.
- Refit the screws securing the sensor.
When refitting the sensor, it should slide into its housing without being
forced. If the sensor does not go in easily, check the mounting hole;
replace the mounting if necessary.
Connection
- Fit the wire onto the chassis and the body and thread it through the sleeve up to the unit.
- Connect the wires on the connector in the right order (see the section on “Connecting to the printed
circuit board”.
- Make sure that the front of the unit and all external fittings are watertight.
- Reposition the hopper on the sensor.
- Refit the securing screw.