KUHN IND 360P, Maintenance Manual, Page: 45 / 54

45
1
2
3
20
10
1
2
3
11
18
13
14
15
16
17
19
21
5
6
7
4
8
9
12
Tools required:
24, 46 and 60 mm spanners, crosshead screwdriver, small electrician’s screwdriver, mallet, brass
punch, lifting rods and jack.
5.3.1 REMOVING THE SENSOR
- Take off the front of the unit.
- Disconnect the faulty sensor, remove the connector and unscrew the cable gland.
- Remove the wire from the weighing unit and from the protective sleeve.
- Take off the clamps and withdraw the wire along the body up to the sensor without damaging it.
- Check that the wire is not damaged, as this may have been the cause of the fault.
Rear sensor
- Raise the body high enough to be able to get the sensor out easily. Fit lifting rods under the body and
under the axle.
- Take off the wheel.
- Take off the brake drum: unscrew the cover (10) using a 60 mm spanner, remove the pin (18), undo
the nut (11) using a 46 mm spanner and remove the washer (12).
- Take out the bearings (13) and (15), then remove the washer (16) and seal (17).
- Remove the pin (19).
- Remove the sensor, taking care to bring the wire through with it (the warranty is void if the wire is
broken); use an extractor if necessary (ALTOR and ATHENOR 8060).
Front sensor
- Dismantle the collar (8): undo the bolt (4) using a 24 mm spanner.
- Take off the pin (7), undo the nut (6), then take off the washer (5).
- Remove the sensor, taking care to bring the wire through with it (the warranty is void if the wire is
broken).
5.3 MACHINE WITHOUT CHASSIS