30/ASSEMBLING THE ENGINE
137
300061-10
–
Insert the pressure piece
.
300052-11
–
Place the pressure cap on.
–
Install and tighten the screws
with the spring retainers and clutch springs.
Guideline
Screw, clutch spring
M5
6 Nm (4.4 lbf ft)
–
Remove the special tool.
19.11
Installing crankshaft position sensor
300151-10
–
Position the crankshaft position sensor
.
–
Mount screws but do not tighten them yet.
Guideline
Screw, ignition pulse gen-
erator
M6
10 Nm
(7.4 lbf ft)
Loctite
®
243™
–
Position the cable and push the cable support sleeve
into the engine case.
19.12
Installing timing chain and timing chain sprocket
300150-10
–
Heat the timing chain sprocket and push it immediately on to the crankshaft.
Guideline
100 °C (212 °F)
–
Mount lock ring
.
300148-11
–
Thread the timing chain
in and lay it over the timing chain sprocket.
Info
If the timing chain is not new, pay attention to the direction of travel.
Summary of Contents for 690 SMC 2008
Page 1: ...REPAIR MANUAL 2008 690 SMC EU 690 SMC AUS UK 690 SMC USA Article no 3206042en...
Page 2: ......
Page 185: ...183...
