KTM 690 SMC 2008, Repair Manual

Page: 85 / 227

14/LIGHT SYSTEM, INSTRUMENTS
83
15.4
Combination instrument - setting/resetting TRIP 2
Info
The TRIP 2 trip counter is always running and counts up to 999.9 .
The trip counter can be used to measure the distance covered during trips or between two refueling stops. After the value
999.9 is reached, the trip counter starts at 0.0 again.
700122-01
–
Switch on the ignition by turning the ignition key in the position (690 SMC EU,
690 SMC AUS/UK) (690 SMC USA).
–
Press the
MODE
button repeatedly until the
TRIP 2
mode is active.
–
Keep the
SET
button pressed.
The
TRIP 2
display is set to
0.0
.
15.5
Combination instrument - setting the wheel circumference
Danger
Voiding of the government approval for road use and the insurance coverage The vehicle is only authorized for operation on pub-
lic roads in the homologated version.
–
If the vehicle is modified in any way, it may only be used on designated tracks away from public roads. Advise the vehicle
owner and rider of this.
–
If you undertake any modifications, please insist on receiving a signed workshop order from your customer in which you
inform the customer in writing that these modifications are performed at the customer's own risk and that the vehicle will
no longer be approved for use on public roads once modified.
Condition
The motorcycle is stationary.
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. ( p. 84)
302064-10
–
Unplug connector ED from the combination instrument.
–
Unlock pin 18

and remove it from connector ED .
–
Plug connector
ED
into the combination instrument.
–
Switch on the ignition by turning the ignition key in the position (690 SMC EU,
690 SMC AUS/UK) (690 SMC USA).
–
Press the
MODE
button repeatedly until the
TRIP 1
display mode is active.
–
Press and hold the
MODE
button for 10 seconds.
The wheel circumference is displayed in millimeters.
302053-10
Increasing the wheel circumference
–
Press the MODE button

.
Reducing the wheel circumference
–
Press the SET button

.
–
Keep the MODE button and the SET button pressed simultaneously.
The settings are saved and the Setup menu is closed.
–
Switch off the ignition by turning the ignition key in the position (690 SMC EU,
690 SMC AUS/UK) (690 SMC USA).
–
Unplug connector ED from the combination instrument.
–
Connect pin 18 to connector ED .
–
Plug connector ED into the combination instrument.
–
Install the headlight mask with the headlight. ( p. 85)